Whirlpool Dryer Heating Element is a post from: Washtek Laundry

Servis 1957 Model 17 Powerglide Washing Machine

Servis Washing Machine is a post from: Washtek Laundry

Dryer Fires Can Be Deadly

Dryer Clips is a post from: Washtek Laundry

You don’t need to spend extra money on gimmicks for a diffuser. They don’t make your hair dry any different than a conventional one such as your stylist uses. Use a low setting for both heat and amount of air. The diffuser reduces the air flow and you don’t want the dryer to overheat.

I have a tourmaline dryer and I love it. Instead of using high heat, I can now use medium heat and still dry my hair in half the normal time it used to take me. This is better for your hair, not to mention your electric bill.

The idea behind the ionic technology is that the ions break down the water into easily absorbable particles that your hair can readily accept. This is supposed to help keep it moisturized. It’s the latest at the hair shows and stylists all over are raving about it. They’re dumping their old straighteners and dryers in favor of the new ionic ones. Do they actually work better? I don’t know about the straighteners, but my new dryer is definitely better than my old one.

Hair Dryer Diffuser Ionic is a post from: Washtek Laundry

at the mo we play monoplay on the wii! lol or watch a film together. then i go off to finish the chores like the dishes from dinner and making more baby milk while he reads his book.

Folding Laundry Table is a post from: Washtek Laundry

…you say you’ve had “it” looked at and it’s fine… well, time to break out the Ol’credit card and buy a new washer… you did say your were “desperate”…

Lint Filter Washing Machine is a post from: Washtek Laundry

You say you’ve located the thermal fuse, it should be the small one on the upper end of the silver element case. It should be held in with one 1/4″ hex head screw and have two red wires coming out of it. If you don’t have a tester, an easy way to check this is to remove the two wires, either slide the two spade clips into each other, or tape them together and then try the machine. If it heats up, then the thermal fuse, (called a hi-limit), was bad and the element is ok. If It still doesn’t heat then there’s a good possibility that the element is the problem. If you have to take the element out, you’ll have to pop the top lid on the dryer, being sure to remove the two little screws under the lint trap flap before pulling it up. There will be a small screw holding a clip on the very top of the element case that must be removed before the case will come out. Unhook the wires from the bottom and remove the case, take the element out of the case and if it’s bad, there should be a break in the coils somewhere. Try to move the coils around gently at several different points and if it’s broken you should be able to see it easily. Once you determine which part is bad you can get the right one an put it back together.

Kenmore Dryer Parts is a post from: Washtek Laundry

I bought deodorant from sams in 2003. I’m still using it!!!!

Bulk Laundry Detergent is a post from: Washtek Laundry

did it totally stop and you could still hear it humming?If that is the case the smell you may have smelled was likely the belt rubbing on a stuck wheel.If it has a direct drive transmission your tranny may be stuck.

Crosley Washing Machine is a post from: Washtek Laundry

Kenmore Dryer Lint Filter is a post from: Washtek Laundry